Need help?Do you have a question about the HP Media Center m1000 - Desktop PC and is the answer not in the manual?
Essential steps to prepare the PC for safe handling and servicing, including reading warnings and using protective equipment.
Detailed steps to safely prepare the PC before opening, including removing media, powering off, and disconnecting cables.
Procedures to follow after closing the PC, covering reconnection of cables, devices, and powering on.
Steps to reinstall the side panel by aligning and tightening thumbscrews on the chassis frame.
Steps to replace the front panel by aligning tabs and snapping it into place.
Instructions for removing an optical drive, including preparing the PC and removing the front panel.
Steps to install a new optical drive, covering cable connections and securing the drive in the bay.
Procedure to remove a memory card reader, involving front panel removal and unscrewing the device.
Steps to install a memory card reader, including attaching the cable and securing it with a screw.
Instructions for removing the hard disk drive, including backing up data and the recovery process.
Steps to install a new hard disk drive, aligning it with the bay bracket and securing it.
Steps to remove a memory module, including preparing the PC and handling the module carefully.
Instructions for installing a new memory module, ensuring correct alignment and seating in the socket.
Steps to remove an add-in card, including preparing the PC and disconnecting any attached cables.
Instructions for installing an add-in card, ensuring proper alignment and seating in the slot.
To Next Page
General