Display assembly
NOTE: The display assembly spare part kit includes the display panel cable, 2 WLAN antenna
transceivers and cables, and a webcamera/microphone module and cable.
Description Spare part number
In gloss black finish 658507-001
In Pacific blue finish 658510-001
In Sonoma red finish 658508-001
WSVGA, HD display assembly in gloss black finish for use only on computer models equipped
with WWAN capability (includes WWAN antenna cables and transceivers)
668166-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 34), and then remove the following components:
{
Service cover (see
WLAN module on page 36)
{
Keyboard (see
Keyboard on page 45)
{
Top cover (see
Top cover on page 48)
Remove the display assembly:
1. Position the computer upside down, with the front toward you.
CAUTION: Support the open display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other computer
components.
2. Remove the two Phillips PM2.0×5.7 screws (1) that secure the display assembly to the computer.
62 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General