Hard drive
NOTE: The hard drive spare part kit includes a bracket and screws.
Description Spare part number
Hard drive:
320-GB, 7200-rpm 627731-001
250-GB, 7200-rpm 613047-001
160-GB, 7200-rpm 622655-001
Hard Drive Hardware Kit (includes hard drive bracket and screws) 626589-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 33).
b. Service access cover (see
Service access cover on page 36).
Remove the hard drive:
1. Disconnect the hard drive cable (1) from the system board.
2. Remove the 3 Phillips 2.0x4.0 screws (2) that secure the hard drive to the computer.
Component replacement procedures 39
To Next Page
Loading...
