4. Turn the computer upside down, with the front toward you.
5. Remove the rear rubber feet, and then the 2 Phillips 2.5x5.0 screws (1) under the feet.
6. Remove the 2 Phillips 2.0x5.0 screws (2) and the 3 Phillips 2.0x4.0 screws (3) that secure the
top cover to the base enclosure.
7. Turn the computer right-side up, with the front toward you.
8. Open the computer as far as possible.
9. Disconnect the speaker cable (1) from the system board.
52 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
