Device feet
The device feet are adhesive-backed rubber pads. The rear feet are attached and the front feet are
tethered to the bottom of the base enclosure.
NOTE: The front and rear device feet are not interchangeable. Due to the adhesive nature of the
rubber pads, they should be replaced after removal.
NOTE: The rear device feet may not be applied on models that use the optional carrying handle
(see
Carrying handle on page 14).
Description Spare part number
Rubber kit (contains 4 rubber device feet – 2 front and 2 rear) 578361-001
40 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
