b. Disconnect the webcam cable (2) from the webcam.
c. Remove the webcam.
6. If it is necessary to replace the non-touch display panel, perform the following steps:
a. Remove the 8 Phillips PM2.5×5.0 screws that secure the display panel to the display
enclosure.
b. Lift the bottom edge of the display panel up from the display back cover (1).
c. Disengage the display panel cable (2) from the left hinge clip.
d. Remove the display panel (3) from the display back cover.
72 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
