Removal and replacement procedures 34
5. Remove the fan blank.
To replace the component, reverse the removal procedure.
Fan
To remove the component:
1. Power down the server (on page 26).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Front bezel" on page 28).
o Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the large redundant fan air baffle, if installed ("Large redundant fan air baffle" on page
31).
5. Disconnect the fan cable.
To Next Page
Loading...
