MSM3xx / MSM4xx Access Points 5.3.5 Release Notes 11 HP ProCurve Networking
Release 5.3.1
Fixes
The following issues have been fixed since the previous release:
ID Description
16439 (Only MSM410 and MSM422 / MAP-625.) Enabling Spectralink VIEW on an AP with an
802.11n radio causes the AP to become unresponsive.
16564 When the main web management tool certificate is missing or corrupted the fallback
mechanism to the default certificate does not work.
18450 (Only European Union.) DFS (5 GHz range) channels 120, 124, and 128 have been
removed due to regulatory changes.
18452 When 802.1X authentication is enabled on a VSC it is now always mandatory. There is
no longer the ability to choose whether 802.1X authentication is mandatory in a VSC. If
you enable 802.1X authentication, wireless devices must be authenticated via 802.1X to
access the network.
19087 The spanning tree protocol s no longer enabled by default on APs operating in
controlled mode.
36647 Service Sensor (Security > Access control > Service sensor) does not work after a
radio configuration change.
36991 The 802.1x supplicant time-out value fails to be applied to EAP Request Identity
packets.
36998 The CLI command mac authenticate radius profile <radiusprofile> is missing.
37054 (Only MSM422 / MAP-625.) A Local Mesh link between a Master node and Slave node
does not always recover when the Master node is restarted.
37097 On APs operating in 802.11b/g mode, if the Allowed Wireless Rates options are
modified for a VSC, all supported wireless rates will be advertised as BSS Basic, which
can cause problems for 802.11b-only clients attempting to connect.
38307 (Only MSM410, MSM422 / MAP-625.) Performance has been improved in power saving
mode when operating in 802.11n mode.
38531 (Only MSM410, MSM422 / MAP-625.) Poor performance may be experienced with Intel
802.11n clients (4965, 5100 and 5300) when they have power-saving enabled.
To Next Page
Loading...
Need help?
General
