Setting up the monitor
Installing the monitor stand
CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause nonuniformity of
color or disorientation of the liquid crystals. If this occurs, the screen will not recover to its normal condition.
1. Attach the base to the stand by aligning the screw on the base with the screw hole on the stand (1), and
then tightening the screw (2).
2. Position the monitor facedown on a at surface covered by a clean, dry cloth.
3. Insert the stand into the slot on the back of the monitor, and press until the stand clicks into place.
Connecting the cables
NOTE: The monitor ships with select cables. Not all cables shown in this section are included with the
monitor.
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Connect a video cable to the video input port.
4 Chapter 1 Getting started
To Next Page
Loading...
Need help?
General
