The monitor automatically scans the signal inputs for an active input and uses that input for the screen.
HP watermark and image retention policy
The IPS monitor models are designed with IPS (In-Plane Switching) display technology which provides ultra-
wide viewing angles and advanced image quality. IPS monitors are suitable for a wide variety of advanced
image quality applications. This panel technology, however, is not suitable for applications that exhibit static,
stationary, or xed images for long periods of time without the use of screen savers. These types of
applications may include camera surveillance, video games, marketing logos, and templates that are
displayed on the screen for a prolonged period of time. Static images may cause image retention damage that
could look like stains or watermarks on the monitor’s screen.
Removing the monitor stand
You can remove the monitor from the stand to mount the monitor to a wall, a swing arm, or other mounting
xture.
CAUTION: Before beginning to disassemble the monitor, be sure that the monitor is turned o and all cables
are disconnected.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a at surface covered by a clean, dry cloth.
3. Press down on the release latch (1).
4. Slide the stand out of the slot on the monitor (2).
Mounting the monitor
The monitor can be attached to a wall, swing arm, or other mounting xture.
NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket.
CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm screws are required. Longer screws
must not be used because they may damage the monitor. It is important to verify that the manufacturer’s
mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor. For
best performance, it is important to use the power and video cables provided with the monitor.
1. Remove the monitor from the stand. Removing the monitor stand on page 8.
8 Chapter 1 Getting started
To Next Page
Loading...
Need help?
General
