HP Officejet 9100 Series - Page 30

24 hp confidential Tour the Product
rear view
rear view
Rear of the Printer
The components located at the rear of the all-in-one are:
1.
Fax "Phone" and " Line in" ports:
The "Line in" port is used to connect the
phone cord from the HP Officejet 9100 series all-in-one to the phone jack
on the wall, for using the fax capabilities of the all-in-one. An additional
device, such as phone or modem can be connected to the phone line
using the "Phone" port to use the phone line for email or access to the
Internet.
2.
EIO slot for HP JetDirect print server:
The EIO slot is used to insert the HP
JetDirect print server all-in-one card for networking.
3.
Parallel port:
The HP Officejet 9100 series comes with a bi-directional, and
IEEE-1284 compliant parallel port. The 1284 parallel port refers to the
connector type at the end of the parallel cable that attaches to the all-in-
one. Some categories of the connector type include 1284-B and 1284-C.
4.
Universal Serial Bus (USB) port:
The USB port is used to connect the to the
computer using a USB cable for plug and play printing support. Unlike the
parallel port, a USB port can be used to connect a single computer to
multiple peripherals at the same time.
5.
Power input connection:
The power input is the interface in which a power
cable is attached to the all-in-one. It provides the required power supply to
the all-in-one.
6.
Auto-duplex unit:
The auto-duplex unit facilitates automatic printing on
both sides of paper. This functionality is not supported for transparencies
and envelopes.