50 3 - Using the all-in-one ENWW
Using photo paper
You can print the photographs that you take with your digital camera, either directly from a
memory card that you insert in the all-in-one or from a software program such as the HP photo
and imaging software. See Printing from a memory card for more information.
Use Best print quality to print photographs. However, with this setting, printing takes longer
and more memory is required from your computer.
The all-in-one can produce 4,800 by 1,200-optimized dpi resolution (up to 4,800 by
1,200-optimized dpi color printing on premium photo papers, from 1,200 by 1,200-input dpi)
when using the following printer drivers:
z PCL 6
Windows 98, Windows Me, Windows 2000, and Windows XP
z PS
Windows 2000, Windows XP, Mac OS 9.2.x, and Mac OS X (10.1.x and 10.2.x)
To print digital photographs
1 Load the appropriate media in tray 1. See Loading the print media for more information.
1 If you want to print photographs from a memory card, insert the memory card into the
appropriate memory card slot on the all-in-one. See Inserting and removing a memory
card for more information.
2 Start the job from your program or from the control panel (see Printing from a memory
card for more information). Make sure that you select the correct print-quality setting,
media size, and media type.
See Changing settings for the all-in-one for more information about setting options.
3 Remove each sheet of media as it prints and set it aside to dry. Allowing wet media to
stack up might cause smearing.
To Next Page
Loading...