70 5 - Copying ENWW
Using presets
If you frequently use the same set of copy options for a particular kind of job, you can save the
options as a preset. You can then apply the preset to future copy jobs.
You can create up to three presets.
To store copy settings into a preset
1 On the control panel, press COPY.
2 Change the copy settings to those that you want to save as a preset.
3 Press M
ENU.
4 Press (down) to move to Set Copy presets.
5 Press - or + to select the preset that you want to save the settings into, and then press
(select).
6 Use the keypad or keyboard to type a name for the preset, or accept the default name.
Then press (select).
A name is optional. If you do not provide one, a default name is used (Preset 1, Preset 2,
or Preset 3).
To apply a preset to a copy job
1 Load the original on the scanner glass or in the ADF. See Loading the originals for more
information.
2 If required, type your PIN on the keypad or keyboard.
3 Press C
OPY.
4 Press (down) to move to Preset.
5 Press - or + to select the preset that you want, and then press (select).
6 Press S
TART.
To Next Page
Loading...