4. Open the computer until the display is at approximately 45° (2), and then close the computer (3). This
step opens the hinges.
5. While pulling the display cable (1) and WLAN antenna cables (1) through the holes in the computer, pull
display away from computer (2).
6. If you need to replace display assembly subcomponents:
a. Flex the top (1) and the inside edges of the left and right sides of the bezel (2) to release it.
b. Slide a at tool (3) across the inside of the bottom of the bezel to release it (4), and then remove
the bezel from the display (5).
The bezel is available as spare part number L99532-001. Bezel adhesive is available as spare part
number L98957-001.
Component replacement procedures 55
To Next Page
Loading...
