HP Omen series User Manual

2. Disconnect the WLAN antenna cable (1), and remove the tape (2) holding it in place, disconnect the
display cable (3), and then release the cable from the routing channels (4).
3. Rotate the display assembly (1), and then remove the display assembly (2) from the base enclosure.
NOTE: For display panel and display component removal procedures, see Display panel on page 60.
Reverse this procedure to install the display assembly.
38 Chapter 5 Removal and replacement procedures for authorized service provider parts

HP Omen series Specifications

General

Brand	HP
Model	Omen series
Category	Laptop
Language	English