11
PCMCIA Type III extender card
The PCMCIA test that makes use of SyCard Technology’s SyCard also requires an extender
card modified with two jumpers or with solder bridges. In order for the Sycard to be detected,
CD1- and GND must be shorted together, and GND with CD2- must also be shorted together.
These are both pairs of endmost pins on the extender. Once these jumpers or solder bridges are
added, the SyCard will successfully be detected and the SyCard tests can be performed. See
Figure 8.
Figure 8 - SyCard Solder Bridges
Solder Bridges
To Next Page
Loading...
