- 17 -
2
1
4
1 Status LED, pouch thickness 125
micron
3 Status LED, cold lamination
2 Status LED, pouch thickness 75/80
micron
4 Operating mode button
Laminator Operating Modes
Hot Laminating
When "hot laminating" mode is active, the laminating pouch is heated to a temperature of approx.
bonding of the laminated material and the laminating pouch. Hot lamination permanently pre-
vents the laminated material from coming into contact with water, oxygen and bacteria.
Cold Laminating
When "cold laminating" mode is active, the laminating pouch is heated to a temperature of approx.
pouches are pressed together during the laminating process.
A detachable bond is produced and the material can be removed if necessary without any dam-
age.
Positioning and Starting Up the Laminator
The following section should help when starting up the laminator.
1 Set the laminator down on a level, stable working surface close to an easily accessible power
socket.
2 Switch the power switch to OFF.
Only use the power cable supplied.
To Next Page
Loading...
