Reverse this procedure to install the hard drive.
Secondary hard drive
NOTE: The hard drive spare part kit includes left and right bracket rails, a connector cable, Mylar
cover with tab, and 4 rubber isolators.
Description Spare part number
1-TB, 5400-rpm 603788-001
750-GB, 5400-rpm 603787-001
640-GB, 5400-rpm 603785-001
500-GB, 7200-rpm 603784-001
320-GB, 7200-rpm 603783-001
250-GB, 7200-rpm 605606-001
160-GB, SSD 603781-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 46).
5. Remove the primary hard drive cover (see
Primary hard drive cover on page 47).
50 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
Need help?
General