d. Peel the tape o the connector on the back of the panel (1), and then disconnect the cable from
the display panel (2).
The display panel is available using spare part number L71938-001 for 220 nit, slim (3.2 mm)
panels, L71939-001 for 250 nit, slim (3.2 mm) panels, L71940-001 for 300 nit, eDP 1.2, ultraslim
(2.6 mm) panels, and L71941-001 for 300 nit, eDP 1.4, ultraslim (2.6 mm) panels.
8. If it is necessary to remove the display hinges:
a. Remove the four Phillips M2.0 × 2.5 screws (1) from the bottom of each hinge.
b. Remove the Phillips M2.0 × 2.5 screw (1) from the top of each hinge.
Component replacement procedures 53
To Next Page
Loading...
