4. Separate the display assembly from the computer (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display bezel:
a. Remove the two screw covers (1) and the two Phillips PM2.0×3.0 screws (2) that secure the display
assembly to the computer.
b. Flex the inside of the top edge (3), the left and right edges (4), and the bottom edge (5) of the
display bezel until the bezel disengages from the display enclosure.
c. Disengage the double-sided tape located in the middle, bottom of the bezel (under the logo) (6).
Component replacement procedures 67
To Next Page
Loading...
