6. To remove the display/webcam cable, remove the cable from the clips built into the display enclosure
(1), and then remove the cable from the display enclosure (2).
The display cable is available using spare part number 833133-001 for SVA, HD displays, 840454-001
for use in FHD, SVA, displays with a 3D camera, and 833134-001 for TOP (Touch On Panel) displays.
7. If replacing the display enclosure, be sure that the subcomponents (including the webcam/microphone
module, the antenna receivers, and all associated cables and hardware) are transferred to the new
enclosure.
The display enclosure is available using the following spare part numbers:
840290-001: White models, non-touch
841942-001: Silver models, non-touch
843213-001: Black models, non-touch
833122-001: Black TOP models
Reverse this procedure to reassemble and install the display assembly.
Display assembly, touch
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 34).
5. Remove the optical drive (see Optical drive on page 35).
Component replacement procedures 73
To Next Page
Loading...
