6. Remove the bottom cover (see Bottom cover on page 38).
7. Remove the system board (see System board on page 56).
To remove the display assembly:
1. Position the computer on its side, partially open.
2. Remove the two Phillips PM2.5×5.0 screws (1) that secure the display assembly to the computer.
3. Open the display to rotate the hinges upward to an angle (2).
4. Separate the display assembly from the computer (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display cover:
a. Pry up on each side of the display to disengage the cover (1).
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
