a. Position the display assembly with the top edge toward you.
b. Remove the Phillips PM2.0×2.0 screw (1) that secures the module to the display.
c. Remove the module from the display (2).
The microphone module is available using spare part number 833148-001.
Non-3D webcam
4. To remove the display panel:
a. Lift the tape that secures the display cable to the connector on the back of the panel (1), and then
disconnect the display cable (2).
b. Remove the two Phillips PM2.0×1.5 screws (3) that secure the display panel to the bottom of the
enclosure.
c. Remove the two Phillips PM2.0×2.0 screws (4) that secure the display panel to the top of the
enclosure.
Component replacement procedures 77
To Next Page
Loading...
