RTC battery
Description Spare part number
RTC battery 697917-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
Before removing the RTC battery, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 33).
5. Remove the keyboard (see
Keyboard on page 37).
6. Remove the top cover (see
Top cover on page 40).
7. Remove the hard drive (see
Hard drive on page 44).
8. Remove the USB board (see
USB board/Audio jack on page 47).
9. Remove the WLAN (see
WLAN module on page 48).
10. Remove the system board (see
System board on page 51).
Remove the RTC battery:
1. Turn the system board upside down, with the front toward you.
2. Remove the RTC battery (1) by pressing down with a thin plastic tool or your finger. The battery
is spring loaded and will pop up. Lift and remove the RTC battery (2).
Reverse this procedure to install the RTC battery.
58 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
