HP PCL 5 - Page 29

EN 27
27
Picture Frame
Picture Frame Horizontal Size in Decipoints
Specifies the horizontal dimension of the area to be allocated for rendering
an HP-GL/2 plot.
? * c # X
# = Horizontal size in decipoints
Picture Frame Vertical Size in Decipoints
Specifies the vertical dimension of the area to be allocated for rendering
an HP-GL/2 plot.
? * c # Y
# = Vertical size in decipoints
Set Picture Frame Anchor Point
Sets the picture frame anchor point to current PCL cursor position.
? * c 0 T
HP-GL/2 Plot Horizontal Size
Specifies the horizontal size of the HP-GL/2 drawing being imported into
PCL.
? * c # K
# = Horizontal size in inches
HP-GL/2 Plot Vertical Size
Specifies the vertical size of the HP-GL/2 drawing being imported into
PCL.
? * c # L
# = Vertical size in inches
Enter HP-GL/2 Mode
Causes printer to begin interpreting the incoming data stream as HP-GL/2
commands instead of PCL commands.
? % # B
# = 0 - Use previous HP-GL/2 pen position
1 - Use current PCL cursor position for HP-GL/2 pen
position
2 - Use current PCL dot coordinate system and old
HP-GL/2 pen position
3 - Use current PCL dot coordinate system and the
current PCL cursor position
Enter PCL Mode
Causes printer to return to PCL mode from HP-GL/2 mode.
? % # A
# = 0 - Return cursor to previous PCL position
1 - Use current HP-GL/2 pen position for cursor position
Learn.fm Page 27 Tuesday, June 22, 1999 8:17 AM