HP PCL 5 - PCL 5 Technical Reference Manual Corrections

ENWW Printer Features 1-5
PCL 5 Technical Reference Manual Corrections
This section describes updates to the PCL 5 Printer Language
Technical Reference Manual (5961-0509). Because this manual will
not be updated, any changes to it are documented in this guide.
Some errors have been identified in the PCL 5 Printer Language
Technical Reference Manual since its printing. Those errors are
identified and corrections are provided on this page.
Chapter 4 PCL Job Control Commands
Unit of Measure Command
In Figure 4-6 on page 4-18, the two escape sequences at the top
should read “(
?&u100D) and (?&u200D)” instead of “(?&u100B)
and (
?&u200B).”
Chapter 8 PCL Font Selection
Transparent Print Data Command
The last sentence in the note at the bottom of page 8-33 should read
“Refer to the PCL 5 Comparison Guide, Appendix A, for character
codes for the various symbol sets.” instead of “Refer to Appendix A
for character codes for the various symbol sets.”
Chapter 13 The PCL Print Model
User-Defined Pattern Command
In Figure 13-10 on page 13-19, byte zero should read Format (20)
instead of Format (0)
On page 13-21, Format (Byte 0) should read “0” for a 300 DPI
user-defined pattern header and “20” for a resolution-specified
user-defined pattern header.