EasyManuals Logo

HP ProBook 4320t User Manual

HP ProBook 4320t
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
15 MultiBoot
About the boot order device
As the computer starts, the system attempts to boot from enabled boot devices. The MultiBoot utility,
which is enabled at the factory, controls the order in which the system selects a boot device. Boot
devices can include optical drives, diskette drives, a network interface card (NIC), hard drives, and
USB devices. Boot devices contain bootable media or files that the computer needs to start and
operate properly.
NOTE: Some boot devices must be enabled in Computer Setup before they can be included in the
boot order.
The factory setting is for the computer to select the boot device by searching enabled boot devices
and drive bay locations in the following order:
NOTE: Some of the boot devices and drive bay locations listed may not be supported on your
computer.
Optical drive
USB floppy
USB CD-ROM
USB SuperDisk
Flash drive
USB hard drive
Network controller
You can change the order in which the computer searches for a boot device by changing the boot
order in Computer Setup. You can also press f9 while the “F9 = Boot device menu” message is
displayed in the lower-left corner of the screen when the computer starts up. Pressing f9 displays a
menu that shows the current boot devices and allows you to select a boot device. Or, you can use
MultiBoot Express to set the computer to prompt you for a boot location each time the computer turns
on or restarts.
If MultiBoot is disabled, the computer uses a fixed boot order that consists of first searching for a
drive A boot device. If none is found, the computer looks for a drive C boot device. Drive A boot
devices include optical drives and diskette drives. Drive C boot devices include optical drives and
hard drives.
The NIC does not have an assigned drive letter.
NOTE: An optical drive (such as a CD-ROM drive) can boot either as drive A or drive C, depending
on the format of the boot CD.
Enabling boot devices in Computer Setup
The computer will boot from a USB device or a NIC device only if the device has first been enabled in
Computer Setup.
70 Chapter 15 MultiBoot

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProBook 4320t and is the answer not in the manual?

HP ProBook 4320t Specifications

General IconGeneral
BrandHP
ModelProBook 4320t
CategoryLaptop
LanguageEnglish

Related product manuals