4. Remove the following screws:
(1) 2 Phillips PM2.0×3.0 screws from the optical drive bay
(2) 3 Phillips PM2.0×3.0 screws from the battery bay
(3) 2 remaining Torx T8M2.5×6.0 screws from the bottom of the computer
5. Position the computer upright and open it as far as possible.
6. Remove the 7 Torx T8M2.5×6.0 screws from the top of the computer.
7. Disconnect the following cables from the system board:
●
(1): Power button board cable
●
(2): Speaker cable
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
