20. Lift the display/webcam cable assembly straight up and off the display panel.
21. If it is necessary to remove the antennas from the display enclosure, remove the antennas from
clips on each side of the enclosure (1), gently lift the WLAN transceivers (2) and the WWAN
transceivers (3) (WWAN models only) to disengage them from the double-stick tape, and then lift
the antennas from the display enclosure.
WLAN antennas are available using spare part number 721507-001. WWAN antennas are
available using spare part number 721508-001.
Reverse this procedure to reassemble and install the display assembly.
Component replacement procedures
85
To Next Page
Loading...
