3. For model 4440s/4441s, remove the two Phillips PM2.5×6.0 screws that secure the keyboard to
the computer.
4. Position the computer right-side up with the front toward you.
5. Open the computer as far as possible.
6. Slide the keyboard downward toward the palm rest (1).
7. Lift the top of the keyboard at an angle (2), and then pull the keyboard up to remove it from the
palm rest(3).
NOTE: Only pull the keyboard up enough to release it from the computer and flip it over onto
the palm rest. Under the keyboard, the cable is connected to the system board.
Component replacement procedures 71
To Next Page
Loading...
