13. Remove the hinges from the enclosure (3).
The display hinges are available as spare part number L78093-001 for nonprivacy models and
L91017-001 for privacy models.
14. If it is necessary to replace the WLAN antennas, remove the cables from the clips in the bottom of the
enclosure (1), and then peel the antennas and remove them from the display enclosure (2).
WLAN antennas are available as spare part number L78070-001.
15. If it is necessary to remove or replace the display/camera cable, use the following steps:
a. Disconnect the cable from the ZIF connector on the camera module (1).
Component replacement procedures 63
To Next Page
Loading...
