3. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3).
NOTE: The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2
black WLAN antenna cable connects to the WLAN module #1 Aux terminal.
4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
WWAN module
To remove the WWAN module, use this procedure and illustration.
Component replacement procedures 43
To Next Page
Loading...
