g. Leave the computer upside down on the table for 20 minutes to allow the adhesive to set.
h. Position the computer upright on a table.
i. Leave the computer upright on the table for 10 minutes to be sure that the panel sits correctly in
the display.
10. If you need to remove the camera module:
▲ Use a tool to lift up evenly across the module and peel the module up from the display back cover
(1), and then disconnect the cable or cables from the reverse ZIF connector on the module (2). The
camera module is available as spare part number N00111-001 for HD cameras and N00112-001
for IR cameras.
NOTE: For installation, note that the cable routes under the camera module before it connects to
the module.
HD camera shown in the following illustration.
Component replacement procedures 65
To Next Page
Loading...
