2. Lift the speakers straight up to remove them (2).
Reverse this procedure to install the speakers.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 6-10
Power connector cable description and part number
Description Spare part number
Power connector cable M21725-001
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 40).
2. Remove the bottom cover (see Bottom cover on page 40).
3. Disconnect the battery cable from the system board (see Battery on page 50).
Remove the power connector cable:
1. Move the antenna cables that route over the right screw (1).
2. Remove the three Phillips M2.5 × 4.0 screws (2) that secure the right display hinge to the computer, and
then rotate the hinge o the power connector (3).
3. Disconnect the cable from the system board (4).
Power connector cable
61
To Next Page
Loading...
