8. To replace the display bezel, remove the two rubber screw covers (1) and the two Torx
T8M2.5×6.0 screws (2) in the bottom corners of the display bezel.
9. Flex the top (3) of the bezel, the inside edges of the left and right sides (4), and then the bottom
(5) of the bezel until it disengages from the display enclosure. Remove the display bezel.
The bezel is available using the following spare part numbers:
683596-001: models without a webcam
683597-001: models with a webcam
Component replacement procedures 81
To Next Page
Loading...
