Fingerprint reader assembly
Description Spare part number
Fingerprint reader assembly (includes cable) 906003-001
Fingerprint reader bracket
NOTE: The ngerprint reader bracket is included in the Plastics Kit.
906001-001
Fingerprint reader insert (for use in models without a ngerprint reader)
NOTE: The ngerprint reader insert is included in the Plastics Kit.
906001-001
Before removing the ngerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in “Battery Safe mode” (Battery Safe mode on page 30).
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door (see Service door on page 31).
b. Optical drive (Optical drive on page 32)
c. Hard drive (Hard drive on page 34)
d. Keyboard (see Keyboard on page 41)
e. Top cover (see Top cover on page 48)
Remove the ngerprint reader assembly:
1. Position the top cover upside-down.
2. Slide the bracket downward and lift it o the ngerprint reader board (1). To slide the bracket
downward, use a at tool and push at the top of the bracket to force it downward.
3. Remove the cable from the clips along the cable routing path in the top cover (2).
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
