6.
Disconnect the power connector cable (9) from the system board (10).
7. Position the system board upside-down (top cover upside-down)
8.
Remove the two Phillips PM2.5×5.0 screws (1) that secure the system board to the top cover.
9.
Lift up the front edge (2) of the system board.
10.
Disconnect the ExpressCard cable (3) swinging ZIF connector from the system board (4).
11.
Remove the system board from the chassis (5).
98 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
To Next Page
Loading...
