Expansion memory modules
NOTE: There are two memory slots. Expansion memory is installed in a compartment containing a
single slot (slot 2) on the bottom of the computer and the primary memory is installed in a compartment
containing a single slot (slot 1) under the keyboard.
Slot 2 cannot be populated if slot 1 is not populated.
Description Spare part number
1-GB (PC3-10600, 1333-MHz, DDR3) 639736-001
2-GB (PC3-10600, 1333-MHz, DDR3) 621565-001
4-GB (PC3-10600, 1333-MHz, DDR3) 621569-001
8-GB (PC3-10600, 1333-MHz, DDR3) 634091-001
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 50).
5. Remove the bottom cover (see
Bottom cover on page 51).
Remove the expansion memory module:
1. Position the computer upside-down, with the front toward you.
2.
Spread the retaining tabs (1) on each side of the expansion memory module slot to release the
memory module. (The edge of the module opposite the slot rises away from the computer.)
64 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
To Next Page
Loading...
