e.
Fan (see
Fan on page 76)
f. Heat sink (see
Heat sink on page 78)
g.
Base enclosure cover (see
Base enclosure cover on page 82)
h. Display assembly (see
Display assembly on page 89)
i. System board (see
System board on page 96)
Remove the ExpressCard assembly:
1. Position the top cover upside-down, with the front toward you.
2. Remove the three Phillips PM2.5×5.0 screws (1) that secure the assembly to the top cover.
3. Lift the tab of the assembly (2) until it disengages from the opening in the top cover.
4. Remove the ExpressCard board and cable (3) from the top cover.
Reverse this procedure to install the ExpressCard assembly.
RJ-11 connector cable
NOTE: The RJ-11 connector cable is included in the Cable Kit, spare part number 639473-001.
Before removing the RJ-11 connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
Component replacement procedures
105
Downloaded from LpManual.com Manuals
To Next Page
Loading...
