a. Lift the tape from atop the connector on the bottom of the display panel (1), lift the connector
bracket (2), and then disconnect the display cable from the display (3).
b. Lift the tape from atop the connectors on both ends of the touch control board (4).
c. Disconnect the cables from the ZIF connector (5) and the reverse ZIF connector (6) on the touch
control board.
d. Disconnect the two at ribbon cables from the reverse ZIF connectors on the touch control board
(7).
e. Remove the cable that routes under the at ribbon cables (8).
f. After disconnecting the cables from the touch control board, you can remove the display panel
from the display enclosure.
g. If you need to replace the touch control board, lift the board up to disengage the adhesive that
secures it, and then remove the board from the display.
Reverse this procedure to reassemble and install the display assembly components.
46 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
