Power connector cable
Description Spare part number
Power connector cable L28264-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in “Battery Safe mode” (Battery Safe mode on page 31).
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door (Service doors on page 32).
b. Keyboard (Keyboard on page 40)
c. Top cover (Top cover on page 47)
d. Battery (Battery on page 52)
e. Display assembly Display assembly on page 62)
Remove the power connector cable:
1. Disconnect the cable from the system board (1).
2. Lift the cable side of the connector upward (2), and the pull the connector (3) out from under the tab (4)
to remove it .
Reverse this procedure to install the power connector cable.
Component replacement procedures 79
To Next Page
Loading...
