EasyManuals Logo

HP ProCurve 5406zl User Manual

HP ProCurve 5406zl
460 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #431 background imageLoading...
Page #431 background image
8-35
Classifier-Based Software Configuration
Traffic Classes
Note If ICMP rate-limiting is already configured on a port, a service policy cannot
be applied to the port until you disable the ICMP rate-limiting configuration.
If you want to apply a service policy to the port, you can maintain ICMP rate-
limiting by configuring a QoS policy in which you add the necessary match
statements for ICMP packets to a class configuration and configure a rate-limit
action for the class in the policy configuration.
For information on globally configured ICMP, refer to the “Configuring ICMP”
section in the “Configuring IP Parameters for Routing Switches” chapter in
the Multicast and Routing Guide.
To apply a service policy on a port or VLAN interface, enter one of the
following commands from the global configuration context.
The following example shows how to apply a QoS policy to a port range and
a VLAN interface.
Context: Global configuration
Syntax: interface <port-list > service-policy <policy-name > in
Configures the specified ports with a policy that is applied
to inbound traffic on each interface.
Separate individual port numbers in a series with a comma;
for example, a1, b4, d3. Enter a range of ports by using a dash;
for example, a1-a5.
The policy name you enter must be the same as the policy
name you configured with the policy command (see
“Creating a Service Policy” on page 8-25).
Context: Global configuration
Syntax: vlan <vlan-id > service-policy <policy-name > in
Configures a policy on the specified VLAN that is applied to
inbound traffic on the VLAN interface.
Valid VLAN ID numbers range from 1 to 4094.
The policy name you enter must be the same as the policy
name you configured with the policy command (see
“Creating a Service Policy” on page 8-25).

Table of Contents

Other manuals for HP ProCurve 5406zl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5406zl and is the answer not in the manual?

HP ProCurve 5406zl Specifications

General IconGeneral
Product NameHP ProCurve 5406zl
CategorySwitch
LayerLayer 3
Operating Temperature32°F to 131°F (0°C to 55°C)
Operating Humidity15% to 95% non-condensing
ManagementSNMP, CLI
Power SupplyRedundant power supplies (optional)
Memory128 MB flash, 512 MB SDRAM

Related product manuals