Figure 3-3. Example of a Basic Connection-Rate Configuration
HP Switch(config)# connection-rate-filter sensitivity low
HP Switch(config)# filter connection-rate b1-b3 throttle
HP Switch(config)# filter connection-rate b4 notify-only
HP Switch(config)# filter connection-rate b9, d1-d2 block
HP Switch(config)# write mem
HP Switch(config)# show config
Startup configuration
: J8697A Configuration Editor; Created on release #K.15.XX
hostname “HP Switch”
connection-rate-filter sensitivity low
module 2 type 8702A
module 4 type 8702A
ip routing
snmp-server communitye “public” Unrestricted
snmp-server host 12.45.200.75 “public”
vlan 1
name “DEFAULT_VLAN”
untagged B5-B24
ip address dhcp-bootp
no untagged B1-B4, D1-D24
ip proxy-arp
exit
filter connection-rate B4 notify-only
filter connection-rate B1-B3 throttle
filter connection-rate B9, D1-D2 block
Shows the per-port configuration
for the currently enabled
connectivity-rate filtering.
Configures the desired
responses to inbound, high
connectivity-rate traffic on the
various ports.
Enables connection-
rate filtering and sets
the sensitivity to “low”.
To Next Page
Loading...
Need help?
General