EasyManuals Logo

HP ProCurve 6200yl Series User Manual

HP ProCurve 6200yl Series
778 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #372 background imageLoading...
Page #372 background image
8-10
Configuring Secure Shell (SSH)
Configuring the Switch for SSH Operation
SSH clients which should have access to the switch. Some SSH client appli-
cations automatically add the switch’s public key to a "known hosts" file. Other
SSH applications require you to manually create a known hosts file and place
the switch’s public key in the file. (Refer to the documentation for your SSH
client application.)
(The session key pair mentioned above is not visible on the switch. It is a
temporary, internally generated pair used for a particular switch/client ses-
sion, and then discarded.)
Note When you generate a host key pair on the switch, the switch places the key
pair in flash memory (and not in the running-config file). Also, the switch
maintains the key pair across reboots, including power cycles. You should
consider this key pair to be “permanent”; that is, avoid re-generating the key
pair without a compelling reason. Otherwise, you will have to re-introduce the
switch’s public key on all management stations you have set up for SSH access
to the switch using the earlier pair.
Removing (zeroing) the switch’s public/private key pair renders the switch
unable to engage in SSH operation and automatically disables IP SSH on the
switch. (To verify whether SSH is enabled, execute show ip ssh.)However, any
active SSH sessions will continue to run, unless explicitly terminated with the
CLI 'kill' command.
To Generate or Erase the Switch’s Public/Private Host Key Pair.
Because the host key pair is stored in flash instead of the running-config file,
it is not necessary to use write memory to save the key pair. Erasing the key
pair automatically disables SSH.
Syntax: crypto key generate <autorun-key [rsa] | cert [rsa] <keysize> | ssh [dsa |
rsa] bits <keysize>>
Installs authentication files for ssh or https server, or for
autorun.
autorun-key
Install RSA key for autorun. See “Configuring Autorun
on the Switch” in Appendix A of the Management and
Configuration Guide for more information.

Table of Contents

Other manuals for HP ProCurve 6200yl Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 6200yl Series and is the answer not in the manual?

HP ProCurve 6200yl Series Specifications

General IconGeneral
BrandHP
ModelProCurve 6200yl Series
CategorySwitch
LanguageEnglish

Related product manuals