6-63
RADIUS Authentication, Authorization, and Accounting
Accounting Services
Note Configuring interim-update for Command accounting results in all commands
being reported as “update” records, regardless of whether common or unique
is configured for the accounting session ID (page 6-60).
Example. To configure RADIUS accounting on the switch with start-stop for
Exec functions, stop-only for system functions, and interim-update for com-
mands functions. This example continues from figure 6-21, where the session
ID was configured as common.
Syntax: [no] aaa accounting < exec | network | system > < start-stop | stop-only >
radius
[no] aaa accounting command < stop-only | interim-only > radius
Configures RADIUS accounting service type and how data will be
sent to the RADIUS server.
< exec | network | system | command >: Specifies an accounting
service type to configure. Refer to “Accounting Service
Types” on page 6-61.
start-stop: Applies to exec, network, and system
accounting service types. Refer to “Accounting
Controls” on page 6-62.
stop-only: Applies to all accounting service types.
Refer to “Accounting Controls” on page 6-62.
interim-update:
Applies to the commands accounting
service type. Refer to “Accounting Controls” on page
6-62.
To Next Page
Loading...
Need help?
General