EasyManuals Logo

HP ProCurve 6200yl Series User Manual

HP ProCurve 6200yl Series
778 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #509 background imageLoading...
Page #509 background image
10-89
IPv4 Access Control Lists (ACLs)
Editing an Existing ACL
To insert a new ACE between existing ACEs in a list:
1. Use ip access-list to enter the “Named-ACL” (nacl) context of the ACE.
This applies regardless of whether the ACE was originally created as a
numbered ACL or a named ACL.
2. Begin the ACE command with a sequence number that identifies the
position you want the ACE to occupy. (The sequence number range is 1-
2147483647.)
3. Complete the ACE with the command syntax appropriate for the type of
ACL you are editing.
For example, inserting a new ACE between the ACEs numbered 10 and 20 in
figure 10-25 requires a sequence number in the range of 11-19 for the new ACE.
Figure 10-26. Example of Inserting an ACE in an Existing ACL
In the following example, the first two ACEs entered become lines 10 and 20
in the list. The third ACE entered is configured with a sequence number of 15
and is inserted between lines 10 and 20.
HP Switch(config)# ip access-list standard My-List
HP Switch(config-std-nacl)# 15 deny 10.10.10.1/24
HP Switch(config-std-nacl)# show run
.
.
.
ip access-list standard "My-List"
10 permit 10.10.10.25 0.0.0.0
15 deny 10.10.10.1 0.0.0.255
20 permit 10.20.10.117 0.0.0.0
30 deny 10.20.10.1 0.0.0.255
40 permit 0.0.0.0 255.255.255.255
exit
Enters the “Named-ACL
context for “My-List”.
Inserts the new ACE.

Table of Contents

Other manuals for HP ProCurve 6200yl Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 6200yl Series and is the answer not in the manual?

HP ProCurve 6200yl Series Specifications

General IconGeneral
BrandHP
ModelProCurve 6200yl Series
CategorySwitch
LanguageEnglish

Related product manuals