EasyManuals Logo

HP ProCurve 6200yl Series User Manual

HP ProCurve 6200yl Series
778 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #706 background imageLoading...
Page #706 background image
14-16
Configuring and Monitoring Port Security
Port Security
Syntax: port-security (Continued)
mac-address [<mac-addr>] [<mac-addr>] . . . [<mac-addr>]
Available for learn-mode with the, static, configured, or
limited-continuous option. Allows up to eight authorized
devices (MAC addresses) per port, depending on the value
specified in the address-limit parameter. The mac-address
limited-continuous mode allows up to 64 authorized MAC
addresses per port.
If you use mac-address with static, but enter fewer devices
than you specified in the address-limit field, the port
accepts not only your specified devices, but also as many
other devices as it takes to reach the device limit. For
example, if you specify four devices, but enter only two
MAC addresses, the port will accept the first two non-
specified devices it detects, along with the two specifically
authorized devices. Learned addresses that become
authorized do not age-out. See also “Retention of Static
Addresses” on page 14-17.
action < none | send-alarm | send-disable >
Specifies whether an SNMP trap is sent to a network
management station when Learn Mode is set to static and
the port detects an unauthorized device, or when Learn
Mode is set to continuous and there is an address change
on a port.
none: Prevents an SNMP trap from being sent. none is the
default value.
send-alarm: Sends an intrusion alarm. Causes the switch
to send an SNMP trap to a network management station.
send-disable: Sends alarm and disables the port. Available
only in the static, port-access, configured, or limited learn
modes. Causes the switch to send an SNMP trap to a
network management station and disable the port. If you
subsequently re-enable the port without clearing the port’s
intrusion flag, the port blocks further intruders, but the
switch will not disable the port again until you reset the
intrusion flag. See the Note on 14-37.
For information on configuring the switch for SNMP
management, refer to the Management and Configuration
Guide for your switch.
—Continued—

Table of Contents

Other manuals for HP ProCurve 6200yl Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 6200yl Series and is the answer not in the manual?

HP ProCurve 6200yl Series Specifications

General IconGeneral
BrandHP
ModelProCurve 6200yl Series
CategorySwitch
LanguageEnglish

Related product manuals