To Next Page

To Previous Page

Removing a 9.5mm slim optical drive

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB flash drives, from the computer.

3. Turn off the computer properly through the operating system, then turn off any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as

the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to

the internal components of the computer.

5. Remove the computer access panel.

6. Disconnect the power cable (1) and data cable (2) from the rear of the optical drive.

CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid

damaging the cable.

20 Chapter 2 Hardware upgrades

Other manuals for HP ProDesk 490 G3 MT

Questions and Answers:

Need help?

Do you have a question about the HP ProDesk 490 G3 MT and is the answer not in the manual?

General