Removal and replacement procedures 43
To install a non-hot-plug hard drive:
1. Remove the top cover.
2. Remove the HDD carrier from the bay you want to install the new drive into.
a. Remove the screw that secures the HDD carrier (1).
b. Push the HDD carrier towards the front of the chassis, and then slide it out of the drive bay
(2).
3. Remove the new hard drive from its protective packaging.
4. Install the new non-hot-plug hard drive module in its carrier.
a. Remove four of the five mounting screws from the carrier (1).
b. Align the hard drive module on the carrier (2).
c. Secure the hard drive assembly with four mounting screws (3).
To Next Page
Loading...
