Removal and replacement procedures 48
c. Place the default optical disc drive on a static-dissipating work surface or inside an anti-static
bag.
4. Remove the new optical disc drive from its protective packaging.
5. Attach the ODD bracket to the new optical disc drive.
a. Align the screw holes on the bracket with those located on the rear of the new drive (1).
b. Secure the bracket with two screws (2).
6. Install the new optical disc drive.
a. Slide the optical disc drive into the drive bay (1).
b. Secure the drive to the chassis with two screws (2).
c. Connect the SATA ODD cable to the new optical disc drive (3).
To Next Page
Loading...
